Assembly for connector with shell width 12.6 mm

1) Connector Placement Insert the connector into the top ram. It will snap in place held by spring loaded balls.
2) PCB Placement Place the PCB on the bottom ram in correct orientation with the help of the guide pins on the bottom ram.
3) Press-Fit Operation Push down the press lever to insert the connector termination tails into the PCB holes.
4) Final Operation Move the press lever up while holding the PCB down until the connector is released out of the bottom ram. The Press-Fit operation is complete.
Caution! The operator must ensure to keep hands away from the rams during press-fit assembly operation!